Refurbished Fusion DRS10/12
The conveyor will accept two 6-inch lamp systems (F300 or LH6) side-by-side for a nominal 12-inch wide system,
or two 10-inch lamps (F450, F600, VPS or LH10) in a two-row arrangement.
The DRS10/12 is designed to accomodate a variety of parts up to 4 inches high.
Standard Feature:
- For use with modular electrodeless lamp system. (sold separately)
- Anti-static, kevlar, mesh conveyor belt.
- 10-150 fpm with adjustable speed control with digital display
- Display speed in m/min. or fpm.
- Vacuum "hold down" facilitates handling of lightweight parts and sheets.
- Emergency stop switch.
- System interlocks for safe operation
- Part up to 4 inches high
- Lamp focus adjustability
- 200/220 VAC, 50/60 Hz, 1 phase, 15 A
- Slip-clutch drive for safety.
- Integral exhaust blower.
Lamp Configurations: (lamps purchased separately)
• F450, F455, F600, LH10*, VPS/I250, VPS/I600:
One lamp wide, one or two rows.
•
F300: Two lamps wide, one row.
•
LH6: Two lamps wide, one or two rows.
(Conveyor base can accommodate two power supplies.)
Width, Nominal: 10 in. (254 mm) or 12 in. (305 mm), depending on lamp system.
Conveyor Belt Width: 14 in. (355 mm).
Length (overall): 66 in. (1676 mm).
Width (overall): 32 in. (813 mm).
Conveyor Belt Height: 32 in. (810 mm) ±2.0 in.
Maximum Part Height: 4.0 in.
Infeed Length, Clear: 15 in. (380 mm).
Outfeed Length, Clear: 11 in. (280 mm).
Belt Material: Kevlar®, Carbon/Graphite impregnated PTFE Coating.
Belt Speed Range: Variable speed in five (5) ranges; 1-15 fpm, 5-75 fpm, 10-150 fpm, 15-225 fpm or 35-500 fpm.
Speed Control: Variable with digital display.
Clutch Slip Limit: 30 lbs. (13.5 kg) belt pull.
Vacuum Hold Down: At infeed, cure zone, and outfeed.
Slider Bed: Perforated aluminum sheet.
Drive System: P.M.D.C. Motor, 1/8 HP.
Lamp Focus: Focal point adjustable from 0.0 in. thru 4.0 in. from belt in 0.5 in. increments (i.e. 2.1 in. thru 6.1 in. from belt to face of lamp).
Exhaust Blower: 1600 cfm (45.3 m3/min.) @ 2 in. SP (outlet). Blower included and installed in base cabinet.
Exhaust Duct Connection Size: 5.88 in. x 11.75 in. (149 mm x 298 mm).
*LH10 lamp system requires a master DeviceNet™ controller to interface with DRS10/12 conveyor.
